Omnicoll fraction collector
INSTALLATION OF COLLECTOR

  ASSEMBLY OF OMNICOLL

• Unpack all components carefully.
• Push the tub-sheet into slots of yellow supports (Fig. 1 A). Insert the black frame into the corresponding slots of yellow supports (Fig. 1 B). Pay attention to proceed at the same speed on both sides otherwise it will come to blocking. The tub-sheet should not slip out of slots.
• Proceed in the same way for the right side.
• Fix both frames in position with four bolts using the hexagonal key (Fig. 2)

• Place the fixing mat in the tub-sheet (Fig. 3 A). When needed clean the mat from dust and dirt with humid cloth. The mat has to be dry again before use.
• A metal rod fixed to the right side frame can be used for fixing of chromatography column, pump etc. Push the metal bar through both fixation nuts and fasten them to the frame with screws Fig. 3 B, C).
• Place the pump support (if needed) on the metal bar (Fig. 3 D)
• It is recommended to use tubings of external diameter of 1.5 to 1.8 mm. Push the tubing through the metal tube so that a tip of about 5 mm comes out of it (Fig. 4 A) and fix the tubing in the right position by screw (Fig. 4 B). Fix the tubing carrying holder with the screw (Fig. 4 C) so that it is about 5 to 10 mm above the tubes in which the fractions will be taken.